1.
Dinghy
a. Battery/solenoid?
– GENE, done
(New starter installed)
b. Reverse
– GENE, done
c. Fuel
filter service
d. Depth
Finder
e.
Zinc - ORDERED
f. Sand
and paint outdrive - DONE
g. Wash
- DONE
2. Electrical
a. Two
side lights - DONE
b. Test
small gen
c.
Beef up Salon lights – DONE
d.
Buy and install reading lights - ARRIVED BUT SENT THEM BACK
3. Engine Room Maintenance
a. Oil
Change - DONE
b. Engine
Zincs - Checked
c. Oil
leaks in ER
d. Clean
up
4. Hull
a. Rudder
post leak
b. Forward
window
c. Forward
bilge
d. Diver
– Inspect and clean hull - DONE (Tightened port prop)
e. Check
Zincs – DONE
(Two new shaft and cutter Zincs installed)
f. Update
zinc supply -
ORDERED
5. Interior
a. Stain
repair holes in teak
b. Secure
the frig
6. Outside
a. Wash
black stains
b. External
paint repairs
c. Varnish
cap rails
i. Sand
- DONE
ii. Clean
- DONE
iii. Varnish
– 8 COATS SO FAR
d. Varnish
steps – 5 COATS
SO FAR
e. Varnish
Flying Bridge
f. Paint
the freezer
i. Deal
with rust
ii. Paint
g. Clean
the stainless - STARTED
h. Wash,
polish and wax – CONTRACTED & COMPLETED
7. Sanitation
a. ElectroScan
Automatic Float valve - DONE
b. Test
“tank near empty” – Buy new switch & Install - DONE
c. Holding
Tank Cap reseal – HAVE THE PARTS
d. Install
new vent – HAVE
THE PARTS
8.
Electronics
a. Auto
Helm 6000 Wired Remote – SENT AWAY – NOT REPAIRED, COMING BACK!
b.
WiFi aerial
- RETURNED
c. Hassle
Direct TV people - STARTED
9. Computers
a. Pilot
House computer power supply
b. Salon
needs security
10. Overhead box on Flying Bridge
a. Buy
starboard - DELIVERED
b. Strip the box - DONE
c. Buy replacement wireless intercom – HAVE ON HAND
b. Strip the box - DONE
c. Buy replacement wireless intercom – HAVE ON HAND
d. Rebuild - DONE
 |
| WOW! Looking great! |
 |
| On the job
Monday May 13th
1. Sanded and varnished - #3 2. Went to the IOP Doctor - ear infection, Vertigo and sore foot 3. Stan and Nancy for dinner Tuesday May 14th. 1. Washed the dinghy 2. Golf card ride around the Island 3. Launched the dinghy 4. Removed the Radio Labs WiFi aerial and packaged for return Wednesday May 15th 1. IOP Pumpout - backed into the slip 2. Emptied motor oil from mains 3. Sanded and varnished the rails (Coat #5) 4. Dismantled and stripped the Bridge overhead electronics box 5. Kylie, Ryan and Mason for dinner Thursday May 16th 1. Shopping 2. Completed oil change with Deidre 3. Sanded and prepped for next varnish coat 4. Dinner with Bill & Laura
Friday May 17th
1. Disposed of the old oil and
bought another 9 gallons. Topped off the engines.
2. Dismantled and stripped the
overhead panel on the bridge.
Saturday May 18th
1. More work on the panel. Fitted
and installed the new "blank" backing board. Waiting for my new saw
Sunday May 19th
One of our friends on the dock showed
me how to check and adjust the valve rockers on the main engines. I really
think it helped reduce the chatter.
Monday May 20th
1. Washed the decks and tidied up.
Tuesday May 21st
Bryce arrived on the
Chrystal Symphony this morning. We were up at 6AM and underway by
6:30AM. The water was calm but it was raining cats and dogs. It took us about
90 minutes to reach the cruise terminal. Bryce walked down to the Charleston
Marine Center where we picked him up and brought him back to the slip at IOP.
After a chat and a couple of beers
we took him for a ride around Wild Dunes on the Golf card and then spent a few
minutes with Kylie and Mason. Then off to Shem Creek for lunch. the rain
continued to fall so we ate inside. Then back over the bridge to give Bryce a
driving tour of historic down town.
We dropped him off at the ship about
4:15PM.
Wednesday May 22nd
1. The clean and wax and polish boys
are back
Wednesday May 23rd Thursday May 24th Friday May 25th. 1. Mounted the new overhead board - looks great!   |
No comments:
Post a Comment